In a typical installation, the NIR sensor is mounted over a conveying system (belt, vibratory, pneumatic, etc.) about 25 cm above the product to be measured.
The sensor shines light onto the surface of the product, and after the light hits the product, the calculations to measure the necessary constituents are done. Filters and cell detectors tailored and optimized for your specific application needs are used to zero in on the exact constituent being measured to provide the best results possible.
The readiness and reliability of this data helps you minimize product loss, eliminate the need for unnecessary downtime, and increases your operation’s efficiency, leading to better margins and increased profits.
Quick Start Guide
ENVEA’s Process Catalogue
M-Sens NIR Software