𝘋𝘺𝘯𝘢𝘮𝘪𝘤𝘖𝘱𝘢𝘤𝘪𝘵𝘺™ Particulate CEM

PCME STACK 602

TÜV approved DynamicOpacity™ particulate monitor for emission measurement of dust from large dry industrial processes including Baghouses and Electrostatic Precipitators

The STACK 602 is a Modbus-based cross-stack optical measuring system which uses a dynamic sensing technique to measure the rate of change of light (DynamicOpacity™ Ratiometric Opacity technology) as particulates pass through a modulated light beam. This proven optical technique, coupled with advanced design features, offers significant reliability and resolution advantages over traditional Opacity monitors and virtually overcomes lens fouling associated with standard Opacity monitors.

Add to Compare
  • Simple installation, set-up and maintenance
  • Resistant to contamination, operational with optics 90% contaminated
  • Lower levels of maintenance than traditional opacity systems
  • Can be purged with instrument air providing lower cost of ownership; blowers available if preferred
  • Used for compliance measurement (mg/m³) after electrostatic precipitators and baghouses
  • Advanced sensor design includes automatic drift (zero and span) checks
  • mg/m³ output, once calibrated.
  • Stacks after bag filters, cartridge filters, cyclones, electrostatic precipitators, no filtration
  • Non-condensing / dry flue gases
    Typical Applications:

  • Incineration
  • Metals (eg Steel/Aluminium)
  • Minerals (eg Cement/Gypsum)
  • Chemicals (eg Refinery / Rubber)
  • Power Generation Plant (eg Coal/Biomass)

Application examples:

Technical Specifications
Measured parameters Dust
Technology DynamicOpacity™
Measurement/Monitoring capability <10 – 1000 mg/m³*
Stack/Duct diameter suitability up to 15m
Flue gas temperature up to 600°C
Baghouse YES
Cartridge Filter /
Ceramic Filter /
Coalescent Filter /
Cyclone YES
Electrostatic Precipitator (ESP) YES
Wet Electrostatic Precipitator (WESP) /
Wet Scrubber /
Sensor variants Stainless Steel
QA checks YES
*Application dependant
Technical data
Measurement capability <10 – 1000 mg/m3
Sensor Variants 316 Stainless Steel (head and coupling)
Stack Temperature Ranges -25°C -250°C (standard) up to 600°C (option)
Functionality and QA Checks Automatic zero, span and light checks
Interface Available with standard control unit (Interface module) for single stack or with ProController for multi-sensor networks
On-board data logging User configurable, Long term, Short term or Pulse logging
Output RS232, RS485 (Modbus), Ethernet Digital Alarm and 4/20mA (number of outputs dependant on controller type)
Air Purge instrument air or blower
Enclosure Protection Rating IP65
  • TÜV approved

Related products

Produits apparentés

Related products

Related products

相关产品

QUOTE DEVIS ANGEBOT OFFERTA 报价 CONTACT CONTACT KONTAKT CONTATTI 联系我们
Go to Top