ElectroDynamic® Approved Particulate CEM

PCME QAL 991

QAL1 approved particulate CEM providing high quality emission measurement for low dust concentrations from dry industrial processes including Baghouses and Cartridge Filters

  • Robust design unaffected by product build-up on the sensor rod
  • No additional services such as air purge required, providing lower cost of ownership
  • Simple maintenance no requirement for specialist service personnel
  • Complies with standards EN 13284-2, EN 14181 and EN 15267-3 and applications with Emission Limit Values (ELVs) of 7.5 mg/m³ (Incineration) and 15 mg/m³ (co-incineration)
  • Automatic recording of drift checks (zero and span) to satisfy QAL3 requirements
  • Networking up to 16 sensor channels via Modbus and providing multiple inputs for external devices such as temperature, pressure and 02 normalisation
  • Stacks after bag filters, cartridge filters, cyclones, electrostatic precipitators, no filtration
  • Variable velocities within range 5 – 25 m/s (typical bag filter velocity ranges)
  • Non-condensing / dry flue gases
    Typical Applications:

  • Incineration
  • Metals (eg Steel/Aluminium)
  • Minerals (eg Cement/Gypsum)
  • Chemicals (eg Detergent/Carbon Black)
  • Power Generation Plant (eg Coal/Biomass)
Technical Specifications
Measured parameters Dust
Technology ElectroDynamic® Advanced Probe Electrification
Measurement/Monitoring capability 0-100 mg/m³*
Stack/Duct diameter suitability up to 8m
Flue gas temperature up to 500°C
Baghouse YES
Cartridge Filter YES
Ceramic Filter /
Coalescent Filter YES
Cyclone YES
Electrostatic Precipitator (ESP) /
Wet Electrostatic Precipitator (WESP) /
Wet Scrubber /
Sensor variants Stainless Steel
Passive/Active
QA checks YES
*Application dependant
Technical data
Measurement capability 0 – 100 mg/m3
Sensor Variants 316 Stainless Steel / Passive/Active (option)
Stack Temperature Ranges 0 -500°C
Functionality and QA Checks Automatic / Zero and span / Short circuit check
Advanced signal processing diagnostics
Audit Unit (option) for linearity tests
Data Output RS485 (Modbus) output to Controller
Air Purge option
Enclosure Protection Rating IP66
  • MCERTs and TÜV (UBA) certified to EN15267-3
  • QAL1 as defined by EN14181
  • QAL3 compliance to EN14181
  • EX Zone 2,
  • US EPA MACT Compliant BLD

Related products

QUOTE CONTACT REQUEST

Compare up to 5 products Show

Previous Next
Close
Test Caption
Test Description goes like this

SOLUTIONS

SERVICES & SUPPORT

NEWS & EVENTS

ABOUT US

CONTACT

This site uses cookies. By the further use you hereby agree. For detailed information, please refer to the Cookies. Ok